Carb help 750j
-
- Posts: 28
- Joined: Sat Oct 08, 2016 2:01 pm
Carb help 750j
Hi,could I have some advice please, I have recently purchased a 750j and I have removed the carbs to put in the ultrasonic bath,I have now come to check the float valve height which my manual says should be 27mm but all are set at around 20mm,also under the valve seat itself there is a fibre washer and an aluminium washer, is this correct and is 27mm the correct height to set them at,many thanks,dave.
-
- Posts: 3120
- Joined: Wed Sep 26, 2012 7:33 pm
- Location: Prestatyn.Wales
Re: Carb help 750j
Hi
Here is the info you require
http://www.ozebook.com/compendium/techb ... %206-9.pdf
The fibre gasket is all that is needed. Any addition will just make float level inaccurate
Here is the info you require
http://www.ozebook.com/compendium/techb ... %206-9.pdf
The fibre gasket is all that is needed. Any addition will just make float level inaccurate
NO SMOKE .......NO POKE
-
- Posts: 3120
- Joined: Wed Sep 26, 2012 7:33 pm
- Location: Prestatyn.Wales
Re: Carb help 750j
Just one more tip. The height is measured from the carb without the gasket.
NO SMOKE .......NO POKE