So treated myself to a nice new electronic ignition kit for the GT380 however the 20 minutes to fit has turned into hours and still not been able to get the bike apart.. I have removed the nut from the end of the points cam shaft but I cannot get the points cam of the shaft.. Is this a common issue and does it mean removing the side casing to press the shaft out and subsequently get the cam off?
Thanks in advance
Dave Bailey...
Points Cam...
-
- Posts: 167
- Joined: Thu Nov 16, 2017 3:10 pm
Re: Points Cam...
Sounds like you have been unlucky. I would try some localised heat with a heat gun, taking care not to damage the nylon cog the other side of the casing. If it still doesn’t shift I would cut down the side of it with a dremil & split it off. Good luck.
- Alan H
- Posts: 12104
- Joined: Fri Aug 05, 2011 6:38 am
- Location: Wombwell, Republic of South Yorkshire
Re: Points Cam...
Oh yes, electronic ignition is better than points - if you can get it on in the first place.
I'll stick to points - thankyou very much - on all three of my triples.
All that technolology crap will never catch on I tell you.
I'll stick to points - thankyou very much - on all three of my triples.
All that technolology crap will never catch on I tell you.
Proof that four strokes are over complicated
-
- Posts: 80
- Joined: Tue May 22, 2018 8:37 pm
- Location: Portsmouth UK
Re: Points Cam...
Ok... so a few things have become apparent today... had to cut the cam bush off... turns out there was no locating pin fitted so possibly explains why difficult to set the timing... question is was the pin not fitted because the nylon sprocket had not been lined up correctly? I guess I’ll find out when it goes back together.....
Dave B
Dave B