position selector
-
- Posts: 110
- Joined: Fri Nov 09, 2018 1:28 am
position selector
Hi, an aid the position of the gear selector spring is correct as shown in the picture, I ask why the gear lever has gone back while positioned the engine on the bench, also looks big and small gear with secondary shaft plug, tell me if it is right. thank you
- malky
- Posts: 1097
- Joined: Sat Dec 19, 2009 3:25 pm
- Location: swansea south wales
Re: position selector
The arms of the spring should go one each side of the pin so that it tensions the selector to centre
Mal.
Mal.
-
- Posts: 110
- Joined: Fri Nov 09, 2018 1:28 am
Re: position selector
Hello, can I push the rod back and place the spring between the pin? look at the position of the selector gears and right, the engine has been stopped in neutral gear, I'm sorry if I ask but I need certainty before mounting the carter, in the manual you do not see this position, if you have a picture or tell me where to find it's nice for me. Thanks you are kind
- canaletto5
- Posts: 5228
- Joined: Tue Jul 23, 2013 8:43 pm
- Location: Derbyshire
Re: position selector
It should be set like this
Kev
Kev
- malky
- Posts: 1097
- Joined: Sat Dec 19, 2009 3:25 pm
- Location: swansea south wales
Re: position selector
The selector rod will just push in and out so you can locate the arms of the spring easily
Mal.
Mal.
-
- Posts: 110
- Joined: Fri Nov 09, 2018 1:28 am
Re: position selector
ok now everything is clear thank you