Need help - perhaps starter clutch
-
- Posts: 33
- Joined: Sat Jul 20, 2019 2:39 am
- Location: U.S.
Re: Need help - perhaps starter clutch
No nylon points gear behind this one ? After researching, that only applies to 380’s. If I’m not mistaken.
-
- Posts: 33
- Joined: Sat Jul 20, 2019 2:39 am
- Location: U.S.
Re: Need help - perhaps starter clutch
I found the problem, fixing it is another issue. The two idler screws are infact the problem. Neither had thread lock on them. Top one was backed out a little and the bottom hole has 2 cracks on the aluminum causing slight movement there too. The cracks must be a common issue as I found a couple similar threads on the internet, I really don’t know how I’m going to do to fix it. One screws threads are warped and I can’t even imagine where to find one the right length ? Only way I see fixing two little cracks is tearing the dam motor apart and replace lower half. What a bummer
-
- Posts: 3118
- Joined: Wed Sep 26, 2012 7:33 pm
- Location: Prestatyn.Wales
Re: Need help - perhaps starter clutch
Yes my mistake getting my bikes mixed uppearly427 wrote:No nylon points gear behind this one ? After researching, that only applies to 380’s. If I’m not mistaken.
NO SMOKE .......NO POKE
-
- Posts: 33
- Joined: Sat Jul 20, 2019 2:39 am
- Location: U.S.
Re: Need help - perhaps starter clutch
I do it myself, good day my friend