Could anyone tell me the float height on a GT380 M please? Also is it set with the carb on its side or upside down?
(this is the one with all three carbs linked together with the rubber boots on the top. NOT the type with 3 individual throttle cables)
Thanks
Tom
What is the GT380 M float height
-
- Posts: 246
- Joined: Tue Oct 30, 2012 5:51 pm
- Location: West Yorkshire
Re: What is the GT380 M float height
Yes that was very helpful. Deciphering that, it would seem it is measured upside down and the height is 25.8mm from top of float to gasket fitting surface. Super!
- yeadon_m
- Posts: 7401
- Joined: Sat Jan 02, 2010 7:10 am
- Location: Canterbury Kent
Re: What is the GT380 M float height
Tilt the carb so that the tang on the float is just touching but not compressing the sprung float needle end , and set to stock float height! If you do it fully inverted the fuel height will be too much and it will run rich! Mike
Re: What is the GT380 M float height
Oh right. Thanks. The doc above is most misleading then. In it the picture shows an upside down carb. I know most bike carbs prefer to be on their side but not all. May I be so bold as to ask your source?yeadon_m wrote:Tilt the carb so that the tang on the float is just touching but not compressing the sprung float needle end , and set to stock float height! If you do it fully inverted the fuel height will be too much and it will run rich! Mike
- yeadon_m
- Posts: 7401
- Joined: Sat Jan 02, 2010 7:10 am
- Location: Canterbury Kent
Re: What is the GT380 M float height
The Suzuki 380/550/750 carb manual itself! the pictures do show it fully inverted. But the words say, and I quote:
"with the carb tilted at 10-30 degrees from vertical, measure the distance from the gasket surface to the top of the float. Adjustment can be made by bending the float arm as necessary'.
It would have helped if they explained why...
Cheers,
Mike
"with the carb tilted at 10-30 degrees from vertical, measure the distance from the gasket surface to the top of the float. Adjustment can be made by bending the float arm as necessary'.
It would have helped if they explained why...
Cheers,
Mike
Re: What is the GT380 M float height
Oh triffic. Thanks again Mike. I've got a Clymer manual for the gt380 but it is an early one and doesn't cover my later style carbs.
-
- Posts: 128
- Joined: Wed Jun 17, 2020 8:55 pm
Re: What is the GT380 M float height
I know this is a very old post but I am having trouble with my carbs
When you say the height is measured from the gasket face is that with or without the gasket installed?
When you say the height is measured from the gasket face is that with or without the gasket installed?
-
- Posts: 3120
- Joined: Wed Sep 26, 2012 7:33 pm
- Location: Prestatyn.Wales
Re: What is the GT380 M float height
Without the gasket. Hold the carb in front of you with the float hanging down. The tang on the float should just be touching the float needle valve. Measure to the top of the float.
Here is the carb manual
http://www.3cyl.com/mraxl/gt/manuals/su ... /cover.htm
Here is the carb manual
http://www.3cyl.com/mraxl/gt/manuals/su ... /cover.htm
NO SMOKE .......NO POKE
-
- Posts: 128
- Joined: Wed Jun 17, 2020 8:55 pm
Re: What is the GT380 M float height
Excellent !!