Unintended GT750B restoration
-
- Posts: 1620
- Joined: Thu May 03, 2012 12:58 am
- Location: Sunny Wales
Re: Unintended GT750B restoration
Never mind the cat send the mrs shopping.
-
- Posts: 402
- Joined: Mon Jun 03, 2013 3:39 pm
Re: Unintended GT750B restoration
With 120 miles up now it's time for a bit of fettling. The bike runs OK generally, but surging is an issue, and the battery is going flat after about 3 days, so two issues to be sorted.
Surging first. I have adjusted the idle screws to 3/4 turn out, and backed the idle adjuster off until it almost stalls. The rev counter isn't moving off the stop with the revs this low so I can't tell you what the revs are! Still surging, but if I leave the choke on it runs great, no surging at all, and sounds crisper all round, so it seems to be running lean generally. Time to check the float heights methinks.
I'll have to check out the charging circuits at the weekend, clearly something is wrong there, it's the second time the battery has drained now. Fortunately it starts first kick.
Surging first. I have adjusted the idle screws to 3/4 turn out, and backed the idle adjuster off until it almost stalls. The rev counter isn't moving off the stop with the revs this low so I can't tell you what the revs are! Still surging, but if I leave the choke on it runs great, no surging at all, and sounds crisper all round, so it seems to be running lean generally. Time to check the float heights methinks.
I'll have to check out the charging circuits at the weekend, clearly something is wrong there, it's the second time the battery has drained now. Fortunately it starts first kick.
-
- Posts: 205
- Joined: Tue Apr 05, 2016 11:00 pm
- Location: Oldham
Re: Unintended GT750B restoration
Phil, just a thought on the surging issue. I am no means an expert but also had the same problem after my rebuild. Tried everything as you do, but i took waterbuffalo's advice on his previous post about retarding the timing slightly.
Although not totally rectified, its much better.!!!!!!!!!
'
Although not totally rectified, its much better.!!!!!!!!!
'
-
- Posts: 402
- Joined: Mon Jun 03, 2013 3:39 pm
Re: Unintended GT750B restoration
Cheers. Yes, I saw that advice and might try it once I'm sure all the carb settings are as they should be. To retard the ignition the back plate would be turned anti-clockwise, is that right?
-
- Posts: 205
- Joined: Tue Apr 05, 2016 11:00 pm
- Location: Oldham
Re: Unintended GT750B restoration
Clockwise, , according to the Haynes bible.
-
- Posts: 402
- Joined: Mon Jun 03, 2013 3:39 pm
Re: Unintended GT750B restoration
I knew it was a mistake, but I did it.I will some time soon go through the pile of invoices I have accumulated, which literally is now 2 inches thick, and tot up just how much this whole thing has cost. I think I'll just enjoy ownership for a while first though .
£12,096.
There are probably a few cash purchases I missed, but that covers all I have receipts for and the few cash purchases I can remember. It doesn't include the purchase price of the bike.
Last edited by philshort7390 on Tue Jun 13, 2017 9:08 pm, edited 1 time in total.
- Alan H
- Posts: 12104
- Joined: Fri Aug 05, 2011 6:38 am
- Location: Wombwell, Republic of South Yorkshire
Re: Unintended GT750B restoration
Just less than thirteen quid isn't too bad mate.........................
Proof that four strokes are over complicated
-
- Posts: 402
- Joined: Mon Jun 03, 2013 3:39 pm
-
- Posts: 3118
- Joined: Wed Sep 26, 2012 7:33 pm
- Location: Prestatyn.Wales
Re: Unintended GT750B restoration
Just imagine how much on top of that the labour charge would be if you hadn't done the work yourself......well worth the cost i must say. A beutiful bike!
NO SMOKE .......NO POKE
-
- Posts: 402
- Joined: Mon Jun 03, 2013 3:39 pm
Re: Unintended GT750B restoration
@barney1 - yes, that's true, I didn't tot up all the hours spent but it would be well into the 100s and would add a few thou to the cost.