Wanted, a set of hen's teeth
-
- Posts: 659
- Joined: Fri Oct 02, 2015 6:59 am
Wanted, a set of hen's teeth
Now, I'm no expert, but I'm guessing THIS is why my lower left pipe is a tad, noisy ?
-
- Posts: 1620
- Joined: Thu May 03, 2012 12:58 am
- Location: Sunny Wales
Re: Wanted, a set of hen's teeth
Looks good enough to repair.
-
- Posts: 659
- Joined: Fri Oct 02, 2015 6:59 am
Re: Wanted, a set of hen's teeth
These are the 2 bits that came out, there is another bit rattling around inside, plus the end piece, currently stuck fast.
-
- Posts: 157
- Joined: Wed Feb 06, 2019 2:43 pm
- Location: West oxfordshie
- Contact:
Re: Wanted, a set of hen's teeth
From the photo it looks like the end bit is still in the mouth of pipe, correct, if so then there's a good possibility the rattle is down to a baffle plate inside has become unwelded, they are just spot welded on the inner side of the muffler/pipe, this is a specialist job to repair, you'll need to have the pipe split down the seams to do a proper job, and then rechromed.
On fragrant cloud
-
- Posts: 3693
- Joined: Wed Jul 20, 2011 3:40 am
- Location: Sydney NSW Australia
Re: Wanted, a set of hen's teeth
Yes I agree, had to do this on my GT750A Model (pre Delkevic's) expensive job to get done at the time over a $ 1,000 Aussie Dollars, Then replaced with second hand set of Delkevic's 18 months later
The bike goes so much better with the Delkevic's,I think the OEM pipes were blocking up with Carbon anyway
The bike goes so much better with the Delkevic's,I think the OEM pipes were blocking up with Carbon anyway
Cheers.
Roger
GT750A.
Roger
GT750A.
-
- Posts: 659
- Joined: Fri Oct 02, 2015 6:59 am
Re: Wanted, a set of hen's teeth
Fortunately Alan H had a set of useable inners, left hand one cleaned up and now fitted,