Hi all, now I have the GT stripped I am contemplating producing a 3D model of it, to what level of detail I'm not quite sure yet.
When it's finished I will be able to save it as and "E" drawing which means anybody should be able to view it as a 3d image and move it around.
I will keep you all posted.
Bod750
3D Model
-
- Posts: 292
- Joined: Mon Feb 01, 2010 1:08 pm
- Location: Isle of Sheppey, Kent
- Contact:
- BAZ
- Posts: 3599
- Joined: Thu Jun 18, 2009 7:35 pm
- Location: Dudley west midlands
- Contact:
Re: 3D Model
Could you show an example of this sounds interesting? Cheers BAZ
-
- Posts: 292
- Joined: Mon Feb 01, 2010 1:08 pm
- Location: Isle of Sheppey, Kent
- Contact:
Re: 3D Model
I'm having trouble getting a file small enough, as soon as I can I will put something on.
Bod750
Bod750
-
- Posts: 292
- Joined: Mon Feb 01, 2010 1:08 pm
- Location: Isle of Sheppey, Kent
- Contact:
Re: 3D Model
Sorry, I cannot get a file below 2mb, although the some of the modelled parts are smaller, when you create the "e" drawing it goes over the forum limit.
I could send something through on an email if anyone would like to see if it works, 2-3 mb.
I have attached some rendered images of the 3D model I produced, which as you can I just made up as I went along, but shows what you can do.
Bod750
I could send something through on an email if anyone would like to see if it works, 2-3 mb.
I have attached some rendered images of the 3D model I produced, which as you can I just made up as I went along, but shows what you can do.
Bod750